2006 EC300 Dash Wiring
Good Morning,
I am in the middle of refurbing a 2006 EC300. The previous owner tore out all the wiring for some reason, cutting all the plugs out, etc.... I have it all running and charging now. I used the sticky above on getting DC without floating ground and worked great. I have all the lighting functioning now but I am stuck with the cut wiring at the dash. I have figured out the status lighting on the sides of the dash, however the 6 wires coming from the center portion of the dash are another issue.... I have the wiring diagram from the manual but I cannot make out the coding for the dash...There are 6 wires: red, black, blue, yellow, green and brown. Can anyone tell me what they are for? Thanks Mike |
incase anyone else has this issue...
Red is switched power Blue ground Green and black are speedo sensor White and brown I am still unsure about but must have something to do with tach... Mike |
1 Attachment(s)
Assuming same model in your region. Yellow wrap around ht lead for rpm (doesn't work that well) . If memory serves, I think the capacitor top left powers the blue backlight.
|
Thank You. Can you make out what the brown wire is power for?
|
No problem! Brown is clock. It needs to be wired to a 12v battery because it will flatten smaller batteries in a week or two. I fitted a small battery holder to my old ec just to have use of the clock for time cards and did without the rest of the time. Probably a legacy thing from the 4 stroke gassers with starter batteries from that period, only on a gasgas :D
|
Thanks for your time, much appreciated.
Mike |
One last question...well maybe one last question... Does the yellow wire pick up its RPM signal from the firing signal to the coil?
Mike |
All times are GMT -5. The time now is 10:14 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org