Gas gas ec 300 crank shaft nut
Hi i need help.
I did a general overhaul. I replaced the crankshaft seals. and when I tighten the nut (crank shaft pinion lock nut).there is the opposite thread. I found on the Internet that he needs to be tightened on 98NM. but when I tighten it to approximately 70NM .the crankshaft is very difficult to turn. should it be? can new seals do it? Thanks for help. And sorry f?r my Bad english. http://www.imageworld.sk/images/sr8y...z0ny_thumb.jpg |
Quote:
|
You should not need much force with the hit.
|
Quote:
If you hit it too hard you could force the crank out of true. |
They generally always need a sharp tap.
|
As above, just eyeball the crank webs in the cases to make sure it is centred.
|
Have you installed the gasket between the case halves?
Sealer alone won't work. |
All times are GMT -5. The time now is 09:03 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org