Husaberg te 300 2012 jetting
I'm new owner of Husa and I'm playing with jetting now.
Now I have 38p, N2ZJ@3 168 pilot as 1.5, temp 10C-25C, alt 800m. I like how bike run but I have some needles and I want to know witch one of those give best torque for my bike,and the needle ar: N8RW,N8RK,N2ZL,N2ZK,N3CW. How will run n3xx vs n8xx? If someone have other needle with good results, can post here. |
#3- NECJ, 40 pilot, 165 main gets you really close.
|
All the needles you listed are the same taper profile
In 1/2 clip variations from leanest to richest they are... N89x=leanest N3Cx N3Ex N8Rx N2Zx N4Dx N3Vx N4Ax N6Mx=richest I agree with ScottyR. Suzi needle will get you close fast! |
NECJ is the most used needle on ktm,very good report,I just ordered one from motocrosscenter.com. , but wath I found also is N3CH with good results.
|
My experience of the n3 vs ne needles the ne is more linear power the n3 is similar on the bottom with a harder (more fun!) hit when you are on the pipe
|
On my KTM's with out my SC or Lectron on them I like the N3CH 3rd 38 165 1.5 out
|
Update: p40 necj.3 main 165. Very smooth power delivery. But I have some hesitation on wide open throttle,sounds clean but has about 1-2 sec of that pause. No sign of topical lean sound booooaaa. When I have tested the needle was a bit cold,under 10C ,and air screw was only 0.5 tourn out.
|
All times are GMT -5. The time now is 07:24 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org