Power Valve Adjustment issue
4 Attachment(s)
Removed cover plug from power valve adjuster and found this....
Attachment 8673 Attachment 8674 Attachment 8675 Attachment 8676 Looks all wrong to me , not like pictures in manual or u tube. Whole assembly seems to be sticking too far out and you can see a large clip at the rear of the shaft which I cant see in any pictures .... .....any ideas what has gone wrong.... HELP! |
|
Quote:
|
I think so too, page 43 shows the bearing in the cover, i'd be pulling it off and inspecting. I think you will find the bearings at the bottom of the motor with what is left of the cage.
|
Quote:
|
Thanks for the replies....any idea what could have caused this to happen?
|
Quote:
They have just forgotten to install the bearing I reckon... https://up.picr.de/37448204ax.jpg |
Quote:
|
1 Attachment(s)
Latest instalment - took the bike to the dealer ...they found the bearing inside the cap
Attachment 8685 Said ..."The bearing sits inside the screw out cap and slides over the shaft as the cap is located and screwed in. ".... I guess that makes sense if you look at the diagram on page 32..if its part number 39. You wouldn't be able to see the bearing that is pressed into the back side of the cover ..part number 12? What do you think? |
Quote:
|
All times are GMT -5. The time now is 03:45 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org