EC250F vs EC250 Cami
Hi all,
I?m looking for a replacement for my Honda CRF230F and a considering a circa. 2014 Gasser. As I?m relatively short (5ft 6?) and light, a bike that has a lower seat height and is relatively light is a definite bonus for me. Initially the Cami seemed ideal for me, but I do get nervous about the Chinese made engine (from what I can tell it is made by a company called Zongshen). Are there any UK based Cami owners on the forum - have you ever needed to order any engine parts and did you experience any difficulties in getting them? Then I started to look at the EC250F. Again it looked good as it has a Yamaha WR250F engine in it, but it seems that it has slightly longer forks and shocks which takes the seat height to 960mm ? making it one of the tallest greenlaners on the market. However it is much lighter at 108kg. Any feedback of the Cami vs the EC250F is much appreciated. One last question; am I right in thinking that the frame, plastics, auxiliaries etc are likely to be the same across the 2014 4s range? Thanks in advance for any replies. |
I'd go with the EC250F
|
Rather than the Cami you might want to take a close look at the AJP bikes from Portugal. I talked to a former GasGas owner who has one and he loves it.
|
Thanks for the replies.
Quote:
Yeah, I've already had a look at an AJP, like you I came to the conclusion that they were tall and the build quality didn't seem up to the standard of a Gasser. If I went down the route of a low seat height, mellow 2 stroke I think that I just plump for the ready made version - a KTM 250R Freeride :-) |
Quote:
In your case, I would go with the 250F. |
That's why GasGas need a EC200 2T.
|
Quote:
|
Quote:
|
What about a 2 stroke 200 or 250? You mentioned that you are 5'6" and light. I am 5'7" and 125 lbs. I've had a KTM 250XCFW back in 2008 and didn't like it. It was too heavy and not enough snap in the motor to lift the front wheel when you need to. Before my gasser I've owned two KTM 200's. I was going to get another KTM 200 or 250 when I came across a great deal on an EC250. I lowered it 1.5" front and rear and love it. I can touch the ground flat footed which gives a lot of confidence in the technical sections. The motor is super smooth and added power over my 200 is icing on the cake when climbing hills.
Sent from my iPhone using Tapatalk |
Forgot to mention: a 2 stroke is much easier and cheaper to maintain. If you are looking at used bikes, purchasing a 4 stroke bike, it could be minutes away from a complete rebuild that would cost a pretty penny. Worst case scenario with a 2 stroke rebuild would probably be half the cost of the 4 stroke rebuild.
Sent from my iPhone using Tapatalk |
All times are GMT -5. The time now is 02:04 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org