Thanks Keg

Hey men. I have just been testing jetting on my new gp300 and am pretty happy with neck, third clip, 180 main, 40 pilot, AS 3turns(so may go 38),and have wound the power valve out 1 turn but will go a bit more to get the bottom end too come on quicker.
australia, not far off sea level, south east qld

Just out of interest, which neelde have you installed?

neck suzuki needle. still need to get the bottom a bit more responsive, so down 1 pilot or up 1 clip

On another note, i have also had the bike at stegz for a measure up and they now have stegz pegz for the gasser.

I love my GP!!!

I try some jetting spec but now i found my favorite

http://fs1.directupload.net/images/180629/kloi3v37.jpg

Hey guys. Im loving the discussion on here and its good to see a few fellow Aussies with the new GP. Im buying a GP250 and wondering who else has one, what jetting specs are you running and as somone said earlier are the squish clearences on the 250 only poor on the EC model or thr GP as well. Cheers. Gian.

My gp300 had a 1.8mm squish with the starndard 0.5mm base gasket. I dropped the squish to 1.6mm by swaping the base gasket to 0.3mm. This cleaned up the bottom end a little bit