Home made disc guard
1 Attachment(s)
Perhaps inspiration for others?
Made out of 6mm aluminum. |
Very nice, but weld it to the carrier. Full length bead. Here in the rocks, bolt ons won't last very long. Usually the tabs are snapped off the carrier. If you make slots instead of holes, you can bend it back straight with a tire iron (stronger than a screwdriver) if needed.
|
Good advice. The tabs looked a little weak.
|
I like the custom shape. Looks strong. Still like your FSE? :D
|
Quote:
Was out riding a power line trail yesterday. Some ice, some snow, some dirt/grass. +4C sunny. 2,5 hours smiling face. The FSE suspension i so smooth.. Yes, I like my FSE more and more each time I get to use it. |
Nice job!......I however, don't have the time to make one. Does anyone sell the guards that fit the FSE front and rear?:confused: Oops! never mind..I just found the link to who makes them. Which ones are recommended?
|
All times are GMT -5. The time now is 01:13 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org