Looking pretty clean! My daughter had 2 (08,09) CR125's and a (11) CR150. National #4 on the 150. Great bikes. YZ 125 front sprocket, GasGas/Sherco rear sprocket. Clutch baskets and clutch hub wear fast on these bikes, but stock replacements are/were fairly inexpensive.

How many hours would you expect out of a clutch?

She looks very nice!

Probably around 50 hours practicing and racing mx. With a 140 lb rider. Most likely much longer in the woods maybe, depending how you ride it and where your riding. Plates were never a problem. The basket and hub just grooved bad in short time.

Sounds like I better keep it in mind and have a check in a few hours when I drop a fresh slug into her.

No history on how hard the previous owner rode.

Got over 130 hours on my clutch still fine never looked at it but as stated mx a bit different!

YZ125 never knew that. Has right offset & everything?

I just got a supersprox front delivered! Will cross reference the part number for ya Craig!

Confirmed the rear is same as Gas Gas. Have one of my spares on it :D

Would any of you lovely Gas Gas folks be kind enough to do me a favour?

I'd like to purchase this: http://www.ebay.com.au/itm/Husqvarna...item440820b1a9

But postage is running around $30AUD, on a $50AUD item. Being a small item I'm sure someone could slip it in an envelope and send it over for a fair whack less.

I've contacted them directly to ask the same thing too.

I'd be happy to do it for you but they don't have a buy it now option.. here's the new listing for it.. http://www.ebay.com.au/itm/Husqvarna...gAAOSw8gVX9Baj