assembly
2 questions, 1] Do you apply assembly lube on the wrist pin rod bearing and or any other area?2] How much lube,pre-mix I assume,is the proper amount for top-end assembly? I have done this before,but for the sake of sounding stupid I've never asked.Any input would be great.Thanks in advance!!!
|
There as many ways of doing this as there is oil stories. Personally i just use a very small amount of oil to make the parts slide together easier.
|
I just lube everything inside the motor with the premix oil you normally mix with your gas.
That way you know it will burn off and/or mix properly and not leave a film of something unwanted. Worked so far for me. K |
All times are GMT -5. The time now is 10:17 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org