Trailtech Voyager Pro and Motominded Stout Mount(100mm Size)
 

I just bought a trailtech voyager pro for the gasser. its pricey but I have been wanting one for a while. I have been using a Trailtech voyager since 2011. I installed the Voyager Pro without any problems and all the regular Voyager wires just clipped right into the Voyager Pro.So,if you have a Voyager installed now then installing the Voyager Pro wiring is simple.

I installed the factory mount that came with the VPro but I didn't like it because it stuck too far/high off the bars. This photo shows it tilted back with the docking station attached, it can be rotated forward but it was still too high off the bars for me.
https://i.imgur.com/ZhyNGYfl.jpg

The is the Motominded AMPs mount for the Voyager Pro in size 100mm(KTMs are 90mm)(this is the measurement between your center hole of the handlebar clamps from left to right.

https://i.imgur.com/VlgGfOml.jpg

https://i.imgur.com/ivh1cm2l.jpg

https://i.imgur.com/5xRtAcIl.jpg

https://i.imgur.com/DrmDzPol.jpg

it mounts much closer to the bars and the mount is reversible up and down and it slides up and down. It is also very rugged and solid.
https://i.imgur.com/xdjIb4sl.jpg

This is the Pro attached to the docking holder.
https://i.imgur.com/nIFf5lCl.jpg

Look in the bottom left and you will notice that I had to run my GPS cable under the handlebar for proper clearance. The mount is very rugged and much stronger and it fits much more closely to the clamps and handlebars.

https://i.imgur.com/MG4U3fBl.jpg