HELP: 2018 GGEC300 Removing starter area conical gear and bearings
2 Attachment(s)
Recently found my bearing seized and the conical gears are not spinning. I sprayed penetrant and unseized the bearing but want to replace it. In what order are they removed and how?
|
I used heat on the starter casting and a few firm taps on the edge of the workbench.
Came out nicely. |
yep, heat around the outside of the case where the bearing lives.
I also made a tool to fit behind the pinion section of the shaft that fitted onto a slide hammer. This helped. |
Hi, is your shaft welded to the gear? Was it come this way or did you do it after?
Thanks. |
1 Attachment(s)
Hello, I used this "tool". Nut and screw. I removed also the gear that is fixed with the axis but i don?t know how to explain in english, sorry.
|
All times are GMT -5. The time now is 09:55 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org