Rieju & GasGas Legacy Riders Club Forum

Rieju & GasGas Legacy Riders Club Forum (http://www.gasgasrider.org/forum/index.php)
-   Enduro Intake/Carburetion - 2 stroke (http://www.gasgasrider.org/forum/forumdisplay.php?f=15)
-   -   02 ec 250 starting problem (http://www.gasgasrider.org/forum/showthread.php?t=16750)

ks9mm 02-16-2014 10:29 AM

02 ec 250 starting problem
 
Hello gang,

Trying to help out friend of mine who just got 02 ec250 and has a hard time starting it.

Bike will start after some serious kicking. Will always start. But Hot or cold it will take some serious kicking. Choke does not make it easier to start when hot.

It will idle fine, but that can just cut of. Very abruptly. Raising idle does not help. But i did not raise idle to screaming levels. It will idle fine and then just cut off.

Once moving, it's a beast. Hard to keep front wheel down. Seems to have almost same amour of power as my 300.

Headlight is always off.

I would appreciate any suggestions.

Thanks a lot!

gassergrant 02-16-2014 11:39 AM

have you tried to clean the carb and make sure its set up correctly ie slow jet main jet. clean the filter too
try a new spark plug just eliminate that em some time if the ring are worn they become hard to start like my bike did.
just some ideas for ya

hamilton 02-16-2014 11:48 AM

Quote:

Originally Posted by gassergrant (Post 128301)
have you tried to clean the carb and make sure its set up correctly ie slow jet main jet. clean the filter too
try a new spark plug just eliminate that em some time if the ring are worn they become hard to start like my bike did.
just some ideas for ya

Check the reeds also.

ks9mm 02-16-2014 11:52 AM

Thank,
Will try to take it apart and clean out and put new plug in. Old plug looked pretty good to me.

My concern is that it shuts of at idle. Would run ..run..seemingly fine and then just cut off, instantly.

Guy who he bought the bike from said that engine had new top end recently...but I guess it's worth taking a look inside.

What's the best place to get complete gasket kit? Top end gasket kit?

Do you think air leaks from crankcase can cause this?

ks9mm 02-16-2014 11:54 AM

Quote:

Originally Posted by hamilton (Post 128303)
Check the reeds also.

Thanks, what should I be looking for?
Both of us are new to 2 strokes.

We switched from 4 strokes.

gassergrant 02-16-2014 01:28 PM

two strokes are easy mate a lot less stuff to go wrong.
you can just get a base gasket and leave the head on. did the fella give you any receipt for new pistons etc
its a carb or plug I bet ya. strip and wash the carb in old petrol and blow out with a air line if not you can get carb cleaner in a spray can.
set the mixture screw to 1 1/2 turns just pull the dial screw and check its not damaged

just a few tip and some bits to look at where in this wide would are you from

gassergrant 02-16-2014 01:40 PM

here is a manual to help with the carb http://www.gasgasmotos.es/en/manuals/models-2-2003.html

ks9mm 02-16-2014 03:48 PM

Thanks! Will try that first

Waiting for bit of a warm weather... It's freezing here in NY..

gassergrant 02-16-2014 04:06 PM

No worries good luck, just wondering if its so cold the bike has trouble starting ???

ks9mm 02-16-2014 04:55 PM

Quote:

Originally Posted by gassergrant (Post 128317)
No worries good luck, just wondering if its so cold the bike has trouble starting ???

We rode only twice since he bought the bike, both times it was barely above freezing with snow on the ground. But above freezing. I would say no more than +5C


All times are GMT -5. The time now is 12:15 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org