Flywheel removal....Thread size.
Hey Guys,
I am about to do the floating ground setup for my Ec300 and will be buying a flywheel puller but cannot remember the thread size that the puller needs to be. Can anyone remember or do they have one they do not need anymore? Cheers Mark. |
Since the ingition is the same as KTM uses, I think any KTM puller will work.
|
2-stroke Kawasaki KX, almost all size bikes use the same from 80 up to the old 500's and that is what fits GG. Do a search for "puller", I posted once with (I think) part numbers and thread sizes.
here, I'll save you the time.... This isn't much but I hope it helps someone, I know I spent considerable time researching it. Flywheel puller for GG 2T (works on both my bikes) is "Magneto/Flywheel/Rotor Puller. 27mm x 1.0mm fine left hand threads. Kawasaki flywheel puller. Most off road and MX and Enduro models. 2 cycle 80 MX to late 500 MX models and KDX Enduros." This from Ricky Stator website. I bought a K & N brand puller (air filter folks) from the local Kawasaki dealer for $30 and it works perfect, part #82-0150. |
Yes, its the common Kokusan flywheel puller. I have a couple of them. One is repackaged as a KTM part in the box with #6 276 807 if that makes things eaiser. That part# is about 10 yrs old.
|
Quote:
A good handy bit of info there jotsby. I will be going to the local kwaka shop asap. Cheers Mark |
All times are GMT -5. The time now is 11:11 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org