The RS125 wheel mystery
5 Attachment(s)
So after doing the TZR125 front and GS500 rear SuMo conversion, I eventually decided it was time to get some proper sized wheels and a nice 320mm brake disc. After a bit of a rear on here and the KTM forums, it appears RS125 wheels are the wheel of choice... So what is required to make the buggers fit?
First off, these wheels are from a 2007+ RS125, and are being put on a 2002 EC300. Front wheel, though the other post states the front wheel requires machining, it does not. To make fit you require - 2x 25x47x12 bearings 1x 25.1x32(minimum)x78.6mm centre spacer 1x 25.1x32x12 disc side spacer 1x 25.1x32x16 hub side spacer 2x 32x47x7 seals Adaptor bracket required has 3 holes Hole 1 - X0Y0 (datum) Hole 2 - X35Y-2.5 Hole 3 - X51.5Y0 Then it must be milled with 12mm clearance on the holes. Rear wheel - Sprocket hub must have 7mm machined off of the disc face, and 6mm off of the hub. Rear wheel must have 3mm off of the disc face and 3mm off of the hub Centre spacer remains the same Disc side spacer 20x32x7mm Sprocket side spacer (stepped) - ID 20 OD1 25x18 L OD2 32x12 L Then just replace all of the carrier and sprocket bolts with low profile button heads, and off you go :D! |
S'funny. I've messed around with lots of RS125 wheels and none of them looked like that.
Honda never ran cush drives on their race bikes.:D |
Quote:
|
Just being silly. A mate has one about that era. Not common here.
|
Quote:
So esoteric it burns !! ;) :D |
Try and contact WAZ . He has RS wheels shown on this post
http://www.gasgasrider.org/forum/sho...ighlight=super |
Mine are on and running mate :D cheers though!
|
All times are GMT -5. The time now is 06:25 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org