Top end rebuild, lots of orings?
1 Attachment(s)
Hi folks,
Finishing off a top end on my mates 03 300. In the gasket kit i have base gaskets, powervalve cover gaskets, reed gaskets, exhaust Orings and gasket, water pump gaskets and head o rings. There is also 7 other Orings. Where do they go? I didn't remove any this size. See pic attached Cheers |
Looks a bit like a full gasket set..
2 x o-rings behind the counter shaft seal. 1 x o-ring on crank, clutch side. Sometimes these kits are a bit generic and will throw in a few bits to cover variances across a couple years of a similar engine. |
Two of those medium orings look like the two I just replaced with my countershaft seal and bushing.
|
Yeah what a screw up that is. Never seen a groove that needed 2 Owings pushing on each other.
|
All times are GMT -5. The time now is 04:00 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org