'10 Sachs fork bleeder thread size
Anyone know the technical thread size for the '10 Sachs fork bleeder screws? I was headed to the hardware store and didn't have the screws in hand. I was going to replace them with phillips screws instead of the allens.
|
They are either M3x0.5 or M3x0.6 ... but I think you need the taper of the current screw to seal the o-ring.
Better off leaving those alone and drilling and tapping for fork bleeders in another part of the cap IMO. |
I could drill and tap. The two screws are the cheapest option though. I noticed that the taper is 45*. I have a hobby shop here in town that has tons of small things like that.
I think I read a post about the drilling and tapping that caused someone a small issue where the new screw interfered with the cap somehow. Thanks for the measurements. |
I replaced mine with fork bleeders.Do it,really useful mod.Just drill out the hole & tap it.You don't need to remove the caps just drop the fork sleeves.But don't get filings in the forks.Bad,very bad.
|
All times are GMT -5. The time now is 10:05 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org