2018 ec300 no start
New to me bike 21hours on it, was a massive pain to start hot or cold when I got it so I did the choke plunger mod, put a #40 pilot jet into it, set the floats, AS 1.5 out, new plug. Also did all the wiring updates for the starter etc.
Now I can't start it at all, no spark when I use the kick starter, but decent enough when estart is pressed (won't start on estart when cold I guess). I am new to 2 strokes but what could I be missing? I just want to ride the thing |
Multi meter time!
Check the resistance for the stator, coil, and ht lead. Worth while checking the flywheel nut as well. A couple have had issues which resulted in the woodruff key sheering and timing going out. |
Thanks, I'll crack into that today
|
0.7ohms on the coil and 9.49(on 20k) on the plug lead.
Can't work out the stator wiring, the only workshop manual I can see has different coloured wires, so I'm abit stumped there. |
Update:
Duh, duh, duh. CDI wasn't plugged in correctly! |
Plugged from you? Did you work on it or it was from factory in that way?
|
The bike had 20hours on it when I purchased it so no idea. I also disconnected the cdi whilst doing some checks, so it may have been my mistake!
|
All times are GMT -5. The time now is 01:22 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org