Whoop Whoop rebuilt crankshaft
 

So after a long wait, I finally have my crankshaft back with me which was treated to a nice rebuild using a Honda CR250R conrod kit.
So now I can start the rebuild I like it done tommorow but its the money side that is holding things back.

Got the new gaskets/bearings/crankshaft/blasted cases now just need to sort out those rough engine cases,a little bit of porting and smoothing work then chocks away.

I know this is a. Longshot but do you or anyone else know the exact width of the crankshaft counter weights (outside to outside)? I've attempted to rebuild mine at home but pressed the pin out before I measured it.
Thanks
Gary.

I?ll measure one up for you later in the week.

That's much appreciated, thank you very much.

Outer to outer, 60.05mm.

Rod side play, 40 thou.

Sorry for giving metric and imperial measurements.

You're a diamond