2011 Engine / Frame alignment question
After 50 hours of riding I pulled my swingarm and linkage to check / grease the bearings. On reassembly, with all other engine mount bolts still tight, the rear engine "hole" doesn't line up well with the frame/swingarm/linkage (the engine sits about 1/16" low). Is this correct, ie is the frame / engine supposed to be connected with "tension", or should I relieve other frame bolt holes to remove it? Thanks for any advise.
|
The swingarm bolt should be the main reference. Loosen eveything else and wiggle the motor until the swingarm bolt lines up.
|
All times are GMT -5. The time now is 01:42 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org