Rieju & GasGas Legacy Riders Club Forum

Rieju & GasGas Legacy Riders Club Forum (http://www.gasgasrider.org/forum/index.php)
-   Enduro Intake/Carburetion - 2 stroke (http://www.gasgasrider.org/forum/forumdisplay.php?f=15)
-   -   Fuel leaks (http://www.gasgasrider.org/forum/showthread.php?t=24672)

(F5) 09-12-2019 02:16 PM

We did a mates last month. Only thing that got it fixed was a new needle.

I drop a ball bearing in the seat and tap it to ensure the hole is round.

But do take your tap out and clean any tank grit. A hair will hold the valve open.

Zman 09-13-2019 04:26 PM

I have had good luck chucking up a cotton swab (Q-Tip), dipped in polishing compound (tooth paste in a pinch) into my electric drill. You can use this to polish the carb seat mating surface so the needle's Viton tip has a smooth surface to mate with or (with which to mate if you are opposed to ending sentences with prepositions) ;-)

https://www.quickanddirtytips.com/ed...-a-preposition

Is it Friday yet?

rodent 09-13-2019 04:44 PM

Actually, it's Saturday morning :D

Gasser Nate 09-13-2019 08:13 PM

Quote:

Originally Posted by Zman (Post 192000)
I have had good luck chucking up a cotton swab (Q-Tip), dipped in polishing compound (tooth paste in a pinch) into my electric drill. You can use this to polish the carb seat mating surface so the needle's Viton tip has a smooth surface to mate with or (with which to mate if you are opposed to ending sentences with prepositions) ;-)

https://www.quickanddirtytips.com/ed...-a-preposition

Is it Friday yet?

This works brilliantly. We used autosol at the bike shop when we had grungey corroded carbs that were sitting around for years in the jap imports.

(F5) 09-13-2019 10:16 PM

We replaced the seal/ball bearing tap after he'd tried this trick.


All times are GMT -5. The time now is 05:30 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org