WTB linkage guard
Looking for a linkage guard for '13 300. I saw the scorpion(emporer racing), but it lowers the rear 3/4"
|
I made one.
http://i267.photobucket.com/albums/i...a9c8698c90.jpg It gets used pretty often. http://i267.photobucket.com/albums/i...B7D1760578.jpg It's just some UHMW plastic sheep from McMaster. |
Nice Shang! thats probably the route I'll go.
|
It's really slippery plastic so it doesn't hang up on anything. It's really easy to work with too. I just cut it with a razor knife.
|
|
McMaster won't let you link the page.
I did UHMW IN 1/2 inch thick. 12x12 sheet. Then I think I just cut it in half. Rounded the rear corners, heated it with a heat gun on the end and curved it a little, then sandwhiched it between the rear skid mount and the skid plate. |
Great. Thanks for all your help man!
|
Sorry!! I was hasty writing that! 1/4 inch thick. Not 1/2!!
|
Quote:
|
All times are GMT -5. The time now is 07:27 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org