Ignition map switch wiring
 

Im pretty sure I know the answer, but...
On my 2014 xc300re, does anyone know if the map switch is in reduced power mode with the circuit closed?

I just replaced my harness and installed a generic switch and want to label it correctly. It's just an on/off switch.

I can check it at my own 15 model, but I cannot do it until tomorrow evening my time. I plan to spend some time in the whokshop then.

On the old bikes (as my 06 model), closing the switch gives you the "sun" setting.

I appreciate you looking, I'd test my original switch bit I threw it out before I realized I needed the info

My switch is similar to my older one; Closed switch = Sun mode.
Open switch = Rain mode.

My ignition module may differ from yours, as I have a 2015 kick start EC200. But I would be surprised if the switches are different https://uploads.tapatalk-cdn.com/201...079805e68b.jpg

thank you very much, I agree there is most likely no difference.

All set!