GasGas Riders Club Forum

GasGas Riders Club Forum (http://www.gasgasrider.org/forum/index.php)
-   Enduro Engine - 2 stroke (http://www.gasgasrider.org/forum/forumdisplay.php?f=37)
-   -   clutch rivet size help and will it fit my 013 (http://www.gasgasrider.org/forum/showthread.php?t=23575)

rvktm 05-16-2018 07:16 PM

clutch rivet size help and will it fit my 013
 
a while back i brought a clutch basket with gear of a gg 250 it has a date stamp of 08 on the basket all the rivets have bean drilled out any one no the size of the rivet , the hole size is 4.2 can i use 1/8 mild steel rivet .also will it fit my 013 300 thanks

Zman 05-17-2018 06:47 AM

I believe standard pop rivets will not work. I would tap the holes and use screws with Loctite like everyone does for aftermarket baskets.

rvktm 05-17-2018 10:18 AM

sorry forgot to say its a gg std basket

Zman 05-17-2018 01:22 PM

I think it is still common for people to tap threads into the stock basket and use bolts to put it back together.

Thompo 05-23-2018 07:07 AM

I used "Reaper Rivets" from a farm shop on a husky I was restoring. I think they are used for holding flail blades onto something, close to 5mm Dia, 20mm long and just cut them down to right length.

I struggled to find the right Dia/length/CSK combination anywhere. Rivets are mainly an aviation thing these days 100/130? csk angle.

5/32 would be a better fit for 4.2mm hole, ideally you would want a 4mm metric rivet. Remember to get a rivet long enough to allow proper forming of the head, typically stack thickness +1.5x dia.
There should enough material to open up the hole a little to allow for a bigger rivet or re-cut the csk to suit something you can get.

EDIT#Never been inside the gasgas clutch so not sure how the rivets are....

rvktm 05-23-2018 12:35 PM

iv found 1/8 cks rivets on uk ebay only 3.00 uk for 10

Zman 05-23-2018 04:11 PM

We're the rivets Aluminum or stainless steel? Please let us know how it works out.

Thompo 05-25-2018 01:47 AM

The rivets I drilled out of the husky were steel.

I replaced them with a steel rivet.

I used something like this http://www.sapphireproducts.co.uk/641t9.htm

robicon 05-25-2018 08:52 AM

I just had this issue I drilled out my only to find the new one was not correct. I did want to wait for a new one. I used stainless rivets and had to peen them for clearance. No problems


All times are GMT -5. The time now is 02:50 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org