rear wheel bearing shim spacer dimensions?
hi does anyone know the dimensions of the spacer that fits between the two wheel bearings on the sprocket side. its like a big washer. i have ordered one but need it before the two week delivery date.
thanks for any info. matt |
What bike have you got?
Is it a Talon hub or a Original GG |
sorry. its a gas gas ec250 with the standard wheels with 2 6004 bearings and 1 6005.
thanks |
Quote:
I have an old wheel that i could knock the bearings out and measure up but i could not do it until the morn (Fri) is that too late It is off a 98 GG not sure if it is the same as yours. My other wheels are talon hubs which i suspect will be different. |
no thats not too late im grateful that you are willing to do this.
thanks very much. would you like to sell the spacer and the circlip from the other end? |
Quote:
|
i was hoping to go out on it next weekend so we have a week to sort something out.
thanks again my email is mattlloyd50@tiscali.co.uk |
Quote:
I will e-mail you tomoz |
I just ordered a 4mm wider inner bearing for mine and shaved 1mm off the outer spacer. I even put the 7mm seal back in and it seemed to work, even though I had a 6mm one for it.
|
FYI-The inner spacer keeps the side pre-load off the inner bearing race when you tighten the axle nut.
|
All times are GMT -5. The time now is 04:38 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org