Rear wheel spacers dimensions needed
Hello guys... would anybody be so nice and measure dimensions of rear wheel spacers for ec 250 2008? I want to have them machines because it is difficult to buy those in Slovakia... thanks a lot
Edit: as i have figured out from used bearings and seals all spacers 20mm ID, right spacer 25mm OD, left spacer 25/32 mm OD, spacers between two bearings is 20x42x2mm. So i need to confirm these dimension and add lenghts for all 4 spacers.. thanks a lot |
1 Attachment(s)
Here is the dimensions I used to make my own spacers (measured in inches). These dimensions have been rounded off a bit, but you can probably deduce the original metric sizes. To convert divide the inches by .03937 for mm.
If you have trouble I can dig out the original spacers and measure them for metric dimensions. These fit 2011, should work for other years. |
I bought some aftermarket ones off some French site by searching for the part numbers. Can't remember. But well made and hard anodised.
|
1 Attachment(s)
Neil... thanks a lot.. it helped... I have converted it... can anybody check those other spacera for me?
|
doesn't the washer have a step on it?
|
Yes it does
|
Quote:
I'll dig out the originals, but I'm sure I machined the step mostly off for the same reason. |
guys... can anybody measure the long spacer in the middle of the rear hub? mine is damaged so I can not figure out how long it have to be... the damaged one is 100.5mm long
|
I won't be having my wheel off for a while, but surely the dimension can be measured from the inner wheel bearing race on each side?
|
thanks, but I need to have new spacers done before I start to disassemble my wheel
|
All times are GMT -5. The time now is 12:00 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org