Rieju MR300 piston end gap specs?
Hello
Anyone knows what is the actual piston end gap min and max spec? Could not find the Rieju workshop manual anywhere. Gas gas manual states 0.5mm to 0.8mm My old original S3 piston was 0.4mm The new S3 piston that I am about to replace is 0.25mm Nothing matches! What do I do?? Thanks |
Quote:
|
Thanks, that's good to know.. But for next time!
I was in a bit of a hurry so I decided to file it down to 0.4mm same as the original piston i removed since it was the same brand (S3). Unfortunately S3 didn't specify any specs or any range of gap clearances, which I think they should. I assume that I am still within spec. . |
A good ring gap is usually 0.005"-0.007" per inch of bore.
Meaning if your bore is 72mm (2.83inches), you want to be inbetween 2.83 x 0.005: 0.014 inches: 0.35mm 2.83 x 0.007: 0.02inches: 0.51mm You want to be inbetween 0.35mm - 0.51mm |
Thank you, it nice of you to share this information. I will keep this notes for the future!
|
All times are GMT -5. The time now is 10:38 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org