Intake rubber
Hi , bit new to all this but has anyone else had trouble with airbox to carb boot going hard ? Mine (2004 EC300 )is almost plastic hard when cold I'm a bit worried about drawing in dirty air when running. Should i just open wallet and buy a new part or is there a scrooges solution ?
|
Go ahead and by a new one, I have an 04 200 and replaced mine with a new one, wasn't that much and sure made getting carb off and on MUCH easier.
Ron |
Quote:
|
Chances are a new one is just as hard. I got one to replace the one on my '03 and it was just as hard Just heat it up real good with a dryer or heat gun, align and tighten it, and post heat it a bit more. Next time it will be a bit better in fit when R&R, but I always still heat mine. This is one detail that should really be improved.
|
Intake boot
OK , thanks for your replies. Yea i thought about the heat gun , but just wanted to check first . Suppose once everything is clamped up tight and leak free ,it wont have to flex much anyway. once again thanks for your help.
|
All times are GMT -5. The time now is 09:14 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org