Rieju & GasGas Legacy Riders Club Forum

Rieju & GasGas Legacy Riders Club Forum (http://www.gasgasrider.org/forum/index.php)
-   All Other Bikes... (http://www.gasgasrider.org/forum/forumdisplay.php?f=35)
-   -   Husaberg te 300 2012 jetting (http://www.gasgasrider.org/forum/showthread.php?t=22630)

adriano.ro 04-29-2017 08:26 AM

Husaberg te 300 2012 jetting
 
I'm new owner of Husa and I'm playing with jetting now.
Now I have 38p, N2ZJ@3 168 pilot as 1.5, temp 10C-25C, alt 800m.
I like how bike run but I have some needles and I want to know witch one of those give best torque for my bike,and the needle ar: N8RW,N8RK,N2ZL,N2ZK,N3CW. How will run n3xx vs n8xx?

If someone have other needle with good results, can post here.

ScottyR 04-29-2017 05:46 PM

#3- NECJ, 40 pilot, 165 main gets you really close.

Jakobi 04-29-2017 09:15 PM

All the needles you listed are the same taper profile

In 1/2 clip variations from leanest to richest they are...
N89x=leanest
N3Cx
N3Ex
N8Rx
N2Zx
N4Dx
N3Vx
N4Ax
N6Mx=richest

I agree with ScottyR. Suzi needle will get you close fast!

adriano.ro 04-30-2017 12:50 AM

NECJ is the most used needle on ktm,very good report,I just ordered one from motocrosscenter.com. , but wath I found also is N3CH with good results.

swazi_matt 04-30-2017 02:36 AM

My experience of the n3 vs ne needles the ne is more linear power the n3 is similar on the bottom with a harder (more fun!) hit when you are on the pipe

Tech51 04-30-2017 01:57 PM

On my KTM's with out my SC or Lectron on them I like the N3CH 3rd 38 165 1.5 out

adriano.ro 05-14-2017 02:51 PM

Update: p40 necj.3 main 165. Very smooth power delivery. But I have some hesitation on wide open throttle,sounds clean but has about 1-2 sec of that pause. No sign of topical lean sound booooaaa. When I have tested the needle was a bit cold,under 10C ,and air screw was only 0.5 tourn out.


All times are GMT -5. The time now is 10:33 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org