CDI/ECU Placement??? Wiring loom , speedometer
Hi all,
I have a gas gas ec 300 2004, I am currently building it from scratch. The previous owner put in over sized piston rings and blew the top. He took the entire bike apart and got fed up with the project so sold it me. Over the years I have been slowly rebuilding it and I'm getting closer to firing the newly built engine for the first time. I have come to the wiring loom , CDI unit and speedometer but can not find the route where the wires go and mainly where the cdi unit sits. Can someone please advise me on the above. Thanks in advance |
The CDI sits on a small flat piece of plastic bolted inside the air box on right side fender just far enough up to clear the filter. The wires come through the upper right front of the air box and cross over above the rear shock and go down to the lower part of the frame going forward. You should see some tabs that are welded to the frame to bend over the wire loom and hold it in place. When you get to the front of the frame/cradle, the coil wires continue around to the right side where the coil bolts on. The rest of the wires go up the cradle to the steering stem, there should be a single yellow wire with a connector on it that the voltage regulator connects to and mounts on the center cradle . The rest of the wires continue up the center frame tube and around the steering stem on the left side into the head light area.
Hope this makes sense. |
I don't have a 04, but I can take some pictures of my half-way dismantled 06 if that is needed. Please let me know.
|
Quote:
|
Quote:
|
Quote:
Sent fra min YAL-L21 via Tapatalk |
All times are GMT -5. The time now is 11:06 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org