Both AC and DC System on '99 EC 250
Hello folks!
I want to put a DC Horn and LED Blinkers on my 1999 EC 250. Therefore I need a rectifier to get the flashing relay as well as the horn to work properly. The headlight and the tail/brake lights I want to keep stock (AC). So I was planning on using this rectifier, as it is very simple. My question is now if this would short anything out? Since the rectifier is connected to the frame/ground via it's metal tab as well as the bike's stator is, I would have AC and DC simultaneously running through the frame which would not work right? Is there another way to have both AC and DC on the bike? |
The unit you have linked looks to be only a voltage regulator. It can only limit your AC output to a specific voltage level. It will not create DC voltage.
If both systems need to be ground you should have a half wave rectifier. The simplest way to get DC is to use an ordinary full wave rectifier and ISOLATE your DC output. Thus the DC is wired directly to your devices WITHOUT the minus connected to ground. |
Quote:
|
All times are GMT -5. The time now is 04:08 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org