2018 Ec300 Jetting Specs
Does anyone have any solid Jetting specs for the 2018 EC 300
Sea level, Hard Enduro stuff. A wee bit on the rich side ok. Cheers |
Quote:
Otherwise I'm sure GGNA will have info for you. Try reaching out to them and I'm sure they will have a jetting table or better for you. |
I went a clip leaner. It helped a lot. I was going to try a leaner pilot but I got a lectron instead. :D
|
Quote:
|
Quote:
My 18 power comes on way stronger then my 2011... |
NECJ #2
MJ 175 PJ 42 AS 1 1/4 1000ft alt 65 - 85 degrees f. 95-98 octane gas |
Thanks Keg I will give it a try.
Went out today with 178 Main 45 pilot #1 standard clip AS 2turns out And had a bog off of idle Thanks for the help Martin |
Anyone tried the N3CH needle yet? It worked very good in the previous models. Rode my 18’ for the first time yesterday and the N1EF needle is just awful. Zero bottom end and then explodes into mega power in the mid to top. Makes it nearly unrideable in anything technical
Sent from my iPhone using Tapatalk |
Quote:
|
Has anyone tried Suzuki needle necj?
In my old yz250x ?16 i run n3ew and n3cw maybe that works for gg300.? I dont like the stock jetting in my gg300?18 way to rich for level. |
All times are GMT -5. The time now is 12:48 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org