Bearing Removal?
Since I have sent my forks and rear shock to Les to be serviced I decided to clean and grease all bearings on my bike.
So yesterday I tore the swing arm off and cleaned and re greased it. I had one pivot point that looked a bit dry but after cleaning it and repacking it it should be fine. I removed the steering stem and cleaned the top bearing and repacked it. The lower bearing seems to be pressed on and I can't get the darn thing off. I cleaned the bottom bearing and repacked it as best as I could but when I put it all back together it felt rough when turning the bars from side to side so I think it would be best to replace both bearings. So how do I remove the lower bearing and do I have to press a new one in? Help a Brotha Out!:D Boom |
All times are GMT -5. The time now is 10:41 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org