Sold! Parting out 2013 300 Updated Pics & Prices - Sold!
 

All sold, thanks!

I am parting out my 300. It was titled as an XC 300 in CA and here in AL it is titled as an EC. All e-start parts already sold. Prices do not include shipping and I am using UPS ground. Prefer Paypal for payment.

Lectron Carb (recently installed). - $old.

Scotts steering damper (complete kit, hardware is rough and bushings and sleeves on bar mount may need replacement. $200

Forks - Sold

Triple clamps & steering stem. (Lower bearing still on stem). $100

Ohlins rear (not pretty but no leaks). $old

Seat, with original pan, batt box, old foam and newer cover - $50

Front number plate with new headlight. $50

Rear tail/brake light. $20

CDI (JD CDI, see pic) - $100

Gas tank (with petcock & fairing screws) - $50

Kickstand assy - sold

Flywheel - $60

Front break assy (master, cable, calipers and pads, recently rebuilt). - $80

Rear brake assy (master, pedal, calipers and pads). - $80

Frame (Comes with Alabama title) - $100

Engine (needs rebuild, top end blew and piston cracked. Metal likely in crank case, needs new gaskets at minimum as leaked all coolant out on trail. Trans works and shifts, missing top end, ignition cover, clutch assy and power valve lever has been cut. See pics) - $old

Right Subframe, new never used, plastic not alum. $40

Wheels (as shown in pics. $old.

Swingarm (rough, lots of scratches & some gouges) $50

PM me with email or text number if you want any better pics or shipping estimates to your Zip code.

pm sent..

I might be down for those forks as well. Are they the Marzocchi PFP 48's?

I don?t know which model they are, only that they are 48mm. I?ll attach a pic of the top if that helps. There is also a nut on the bottom that had to be removed to get them apart when I changed the oil and seals last.

Is the fuel tank available?

Yes, I have it, but haven't dug it out yet or got an idea on pricing.

You had mentioned that you were in Lower Alabama looking for riding opportunities. If you are in or near Mobile, I've got the location of a 22 mile single track loop, with free parking, that I'd trade for the seat pan if it fits an '11 300.

BD-
You might also look at Brewton. There is a club and shop up there that has a nice area. I don't know if you need to be a club member. I've "raced" their annual hare scramble a couple of times. Fun event.

I'll take a rear master cylinder for that piece of information if it pans out for you.....

2011 was the last year of the small GG. I don't think the 2012+ will fit.

Thanks, but the seat has been requested by another member already. Gonna update all the pending parts.

Bear with me everyone, this is my first part out and I?m doing my best to get boxes and shipping estimates for everything.