Confirm Torque Specs for Forks/Linkage for 2018+ EC300?
1 Attachment(s)
Have my owners manual and found what I think is the upper and lower triple clamp torque specs, but would like to confirm before tightening them down. (See attached). Looking at the Upper and Lower flange torque specs.
I like to loosen and retorque my forks after each ride (drop :p) to make sure everything is all aligned up correctly - torque the bolts to the correct torque is also important. Also in the manual it says "Link", which I assume is linkage, and all the nuts are at 80nm - This sounds about right, but would like to confirm before bringing down the torque. |
|
Thanks for sharing the workshop manual, but i can't find anything about the suspension in it, seems to be only engine related.
|
Quote:
|
What are the specs for your 2015 out of curiosity ?
|
Yes upper and lower flange is triple clamps and link is linkage.
|
There is a torque table in the workshop manual for every bolt on the bike.
|
Quote:
Lower: 11 Nm |
Bumping this up - I have my front wheel off and want to torque up the pinch bolts for the axel. Do you think it is the "foot fork" at 15nm?
|
Quote:
|
All times are GMT -5. The time now is 10:03 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org