O-Rings for clutch slave 2018/2019 300's
When I had clutch problems I replaced the slave cylinder and found that it has a piston with one groove.
The new slave, ordered from GasGas with original GasGas part number has a different piston with two grooves and two o-rings (picture below). I would like to have spare o-rings but it seems they are not available through Gasgas. Any ideas? https://up.picr.de/37126252nq.jpeg |
I would use a micrometer to measure the dimensions of the o-ring. You should be able to source the o-rings after you have the correct dimensions.
|
Yep, already considered that, but it would have been easier to buy them from GG. Obviously they aren't available so that is the only way to go then. Thank you!
|
Quote:
|
All times are GMT -5. The time now is 07:04 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org