We're at different stages of our kit installs but this is what I've found so far.
Make sure the subframe/tail is centered over the rear wheel. The hole location was off on mine at the right top strut that mounts by the tank. If forced into position it made the subframe crooked
Obstacles so far with my 2000 EC250 (not done yet)
*Hole location off on one subframe strut (top right)
*2000 or 2011 FMF TC2 silencer won't fit correct
*Shrouds needed sanding/fitting on the inside to mount to the tank decent
*seat fits very very snug to back bone of the fuel tank
Could your side stand just be bent/tweaked out a bit to clear?
Good luck with the project!
Noah
__________________
Noah
2000 EC250 with 2011 transformation kit, KYB SSS forks, MN street title
16' Ski-Doo XS Renegade X 1200 4T
16' Specialized Fatboy trail
02' ZRX 1200r R.I.P.
72' Olds 500ci, Batten Heads, Street/Drag car, former CarCraft magazine centerfold (has-been
)
15' TW200