Quote:
Originally Posted by PEB
Now if I could just figure out a way to bend the left ignition side of it back about an inch so it doesn't kiss the frame rail.
Paul B
|
You can usually bend them back with a little persuasion.
I usually put it on a towel on the ground and put a long piece of pipe in the cylinder end for some leverage and lightly step on the other end to hold it in place and pull the piece pipe back slowly in the direction of the desired position. Test fit and keep tweaking it till you get it right. Good luck.
Roscoe
__________________
Huge thanks: GAS GAS OFFROAD US, Skagit Powersports, Cycle Gear, LTRacing, Scorpion Racing, users of GasGasrider.org, and CFMC!