There is a bit about setting the float level in the manual so once you get yours it should be pretty clear.
What I do is remove the carb from the bike and then remove the float bowl keeping the carb level all the time not to spill fuel. Measure the fuel height in the bowl to get a base setting. Adjust the tab on the float arm in the direction you want to go (lean, rich). Drain the bowl and mount it back to the carb with only two screws. Now comes the tricky part. Connect the fuel line to the carb (still off the bike, no slide), open the choke and slowly start opening the fuel tap. If you did it right no fuel will gush out of the metering tube and you can go back to step one and measure again.
Michael
|