Another important question, do I need to use Loctite (and what type) on the junction of the PFP and the compression stack(?) rod? In this pic from Vindicator, where these two parts thread together underneath the PFP spring? Also, am I correct in that this is where you adjust for the proper amount of compression clicks or is that a different spot?
The stack in the cartridge. Does it look ok?
(Left to right, top to bottom)
Bolt
Spring
31.85 x .3
Base
11 x .3
11 x .3
18 x .1
20 x .1
24 x .1
13.8 x .1
31.8 x .15
31.8 x .15
28 x .1
2.5 spacer
Lastly, in between those two parts mine has a circlip on each one. No clue why they're there as I haven't seen them in any other pics of this junction.