thanks!
i compared the two sets and figured that the kit covered a couple different engine sizes... only markings were 2005-2006. Yep...there were two in the pack that would be a stretch to get on..
But, I got the larger of the two sets on after some messing around and they felt smooth.
I figure I have the power valve plate on correctly...(the little arm comes up into the power valve area and connects to the plate on the threaded post while it's on the left of the pivot point). In this position I can look up into the exhaust port and see the power valve and ports closed up.
thanks!
rich
****** there was a little sort of thickish washer that was beveled on both sides.. I hope it rests behind the power valve plate(sort of on the threaded axle that goes through the pwer valve bearings.
|