I called half a dozen dealers to see if one had the washer and would measure it, but no one did. I have 2 GG, one with a good clutch, and what I am thinking about doing is taking the good set out and adding 4 of the newer, thicker clutch plates to the bottom of the stack because thats seems to be the ones that break, and taking the 4 that I take out and putting on the outside of the other bike with the 4 new ones again in the bottom. This may or may not give me enough clearance, but I figure its worth a try.....
I wonder if you had a piece of round stock around 1mm longer than the clutch rod if it would work with the full pack of thicker clutches or is the problem not with how far it pushes but more of a clearance issue?
__________________
2006 EC300, 2000 XR650R, 2003 EC250, 2001 EC200 (OK, the last two are really my sons).
|