Quote:
Originally Posted by Troy F collins
Good report...
I was able to cut about 5mm off the threads of the brake pushrod without removing it from the bike..with a cut off wheel..took 5 min I like to be able to reach for the rear brake....instead of having it under your toe all the time kinda smells funny after a while ? 
Mine jetting was ok at 2000ft 70 F....but sucked at low temps High alt.....I did exactlly the same as you with jetting....yes the low end burble is annoying ......Did you get a different CHN needle in "the kit"
CCK (sudco) or N3EG N3CH (dealer)other options |
I didn't get two needles
I may try a JD kit, although I haven't seen a whole lot of reports about JD's GG kits.