no worrys!
I rode sunday, started at 9 am 1500' elevation and temp was 66 f. rode to 3600' temp was at 58 and then rode back to 1500' at 1 pm with a temp of
81. Bike did NOT deviate from perfect! I would rather learn by test and re-test than take the word of some self proclaimed smart guy only to find out said smart guy is a 8th grade drop-out that has been monkey mechanicing with not as much ..............oh yeah, by the way I measured the taper on the needle(w/micrometer), measured the height at which the taper began and measured the amount of slide lilft and surmised the full diameter of the neddle was still in the main jet after the spring was cut and the slide was raised approx .5 mm! just remember air passing through the carb is required for the idle circuit to siphon fuel and feed the engine, making the piston going up and down via small internal combustions! perhaps you have heard of the internal cumbustion engine?
|