Quote:
Originally Posted by Bailey28
I ordered an N3EH and an NOZH today. I am anxious to get them in the mail and start experimenting again for the hot weather.
I also found a post on trimming the jet shroud nozzle screen, the part that sticks up into the venturi. I had this done by Ron on my old KDX carb and it cleaned up the 1/8 throttle burble.
I may try to shave 1mm off the screen height, it is supposed to lean the mixture in this area the same as if you changed to a # leaner slide.
|
You should see if you can get an N3EJ or N3CW aswell Bailey. I had the best results with the N3EJ out of all the N3 range needles I have tried. The W is one step richer on the diameter and the C half a clip leaner. Good for fine tuning.
I'd actually like to try an N1EJ to see how that alters the power curve.