Quote:
Originally Posted by wasp4banger
Sorry to correct you Matt, but the above would give the area of the internal curved surface, pi x d gives the perimeter I'm afraid. (unfortunately for me, I'm a far better mathematician than rider!)
about 100cc per leg I reckon. The volume should be pi x id x id x h / 4, remember area is (pi x id^2) /4 or pi x ir^2.
Hope this helps.
|
You are 100% correct. I was going to sleep when I did it and this morning it struck me! Was hoping I could sneak back in and change it without anyone knowing lol
As for deducting spring and push rod, isn't the oil height measured with all of this removed? So all you need to do is to do the calc, get a cc syringe and add through the bleed hole