thanks for the advice jakobi you seem to be a jetting guru around here , i put a 38 pilot in smallest i had, moved the clip to 2 and managed to get the idle screw 2.5 full more turns out and it was 2 turns out on the air screw. I havnt done a test ride as its been hammering down with rain so i dont know how it rides.
How far should the idle screw be out? when i took the carb off to change the pilot i had a look at the slide it was prob 2-2.5mm[guess] gap and when i wound out the idle screw it took 4 full turns to bottom the slide with no gap, does the slide need to be bottomed with no gap? This might be a stupid question but what is the idle srew for? if it should be in a certain position and you set the idle by getting the right pilot and needle? the more i learn about jetting the more confusing it is haha! its all fun tho
|