Quote:
Originally Posted by Jakobi
Stolen from an earlier post on DBW today!
You need to use one hand to bind up the spring and plastic retainer towards the top of the throttle cable. Then push in slightly and the cable will come out of the locating groove in the 6mm retainer.
Once you have the slide out you need a 6mm socket to undo the retainer in the top of the slide. Tip it upside down and the needle and clip slide out as one. To remove the clip I like to put the needle on a clean solid surface and gentle push each side of the clip unti it starts to pop off. Be careful not to launch it into the abyss!
Putting it back together is the opposite. Take care not to over tighten the 6mm retainer in the slide. Bind the spring up and make sure the cable slides in and mounts properly into the slide. Then when you let the spring back down make sure the little lug in the plastic part locates into the groove in the 6mm retainer. Test the throttle action before taking off for a test ride!
|
Outstanding! 2am comes quick, so the carb is again a "tomorrow" deal. Thanks all, for the much needed help.