08 EC300 Marzocchi Shiver stock lower stack
OK. I wasted a bunch of time trying to get the information I needed from Marzocchi USA technical support. After one email and three phone calls in three days, finally someone called me back. Of course, I missed that call due to signal issues on my cell phone. Didn't matter. They didn't have any idea what the stock stack was. The voice mail I got said they could try to email Italy, but didn't know if or when they might hear back.
I'm not impressed with Marzocchi USA customer care.
So, I went ahead and tore #1 apart again. Here's what I found for a stack on the bottom valve (compression) starting at the bottom:
6- 22mm, .12mm thickness
11mm, .2 thickness
12 through 21mm in sequence
Piston
22mm, .31 thickness
Reassembled #1, then #2 using that sequence with 610cc each of Honda SS-7, 5 wt. Good to go!
|