Few pictures of the cases.
Some casting differences, crankcase is the same dia. 111mm
Most things seem to fit bar the crank etc mentioned above.
Mounting points will need drilled out.
2001 14mm swing arm and 8mm frame bolts.
2006 18mm swing arm and 10mm frame mounts.
So as an aside, given the gearbox, clutch, powervalve etc is common across the 200/250/300 and cases are supposedly different on the 200, what is the difference? Anyone got 250/300 cases care to measure the crankcase dia?
At this point, its looking like a whole lot hassle to make the 01 cases work. Will probably go the route of welding the re-drilling or sleeving the existing mounts.
Cheers
Last edited by Thompo; 09-05-2018 at 04:08 AM.
|