[Moto7man]

I cleaned the rust out of the barrel with a scotchbrite pad. It doesn't look took bad but there is some pitting in the bottom 1/4 of the barrel. Will a hone take this out this pitting or do we need to bore the liner to .25 over to the 1st oversize piston?





Also, the piston only has an arrow on top (to be installed point to the exhaust port) and a number "3" stamped inside the skirt. I took a measurement of the piston and it was 69.900 which is close to the service limit for a std bore piston and the ring end gap was right at the the .85 ring end gap service limit.

* Does the #3 on the piston mean it is a std size piston within the production limits, like A;B;C marked pistons for niksail cylinders or is it something else?